The table below lists and explains names and meanings of the SAP parameters. These values are tuned by editing the /etc/default/LifeKeeper configuration file.
| SAP_DB_CHECK_IGNORE | While attempting to start a protected SAP instance, the SAP Recovery Kit checks the status of the associated database (whose information is obtained from the SAPDBHOST/dbtype/dbname/dbhost SAP profile parameters) using an saphostctrl GetDatabaseStatus call. This parameter may be set to 1 to disable the database status check. |
0:Perform database check |
0 | As required (takes effect immediately) | Set this parameter value to 1 if either the database is not protected by SIOS LifeKeeper or if the database check performed by the SAP Recovery Kit is failing unexpectedly. |
| SAP_CONFIG_REFRESH | Refresh time in seconds of the Configuration properties page. | Integers | LKCHECKINTERVAL/2 | As required | If the value is less than 5 seconds, it will be set to the default. |
| SAP_CREATE_NAS | Automatically includes a NAS resource for NAS mounted file systems. | 0:disabled 1:enabled | 1 | As required | |
| SAP_QUICKCHECK_TIMEOUT | Timeout in seconds for the quickCheck process. | Integers | 60 | As required | |
| SAP_RESTORE_TIMEOUT | Timeout in seconds for the restore process. | Integers | 1048 + SAP_QUICKCHECK_TIMEOUT | As required | |
| SAP_REMOVE_TIMEOUT | Timeout in seconds for the remove process. | Integers | 540 + 2 * SAP_QUICKCHECK_TIMEOUT | As required | |
| SAP_RECOVER_TIMEOUT | Timeout in seconds for the recover process. | Integers | SAP_RESTORE_TIMEOUT + SAP_REMOVE_TIMEOUT | As required | If the value is less than the default, it will be set to the default. |
| SAP_DEBUG | Enables debugging. | 0: disabled 1: enabled |
0 | As required |
このトピックへフィードバック