In the event that the primary server has attempted and failed local recovery or failed completely, most server administrators will want LifeKeeper for Windows to automatically restore the protected resource(s) to a backup server. This is the default LifeKeeper for Windows behavior. However, some administrators may not want the protected resource(s) to automatically go in service at a recovery site; for example, if LifeKeeper for Windows is installed in a WAN environment where the network connection between the servers may not be reliable in a disaster recovery situation.
Automatic failover is enabled by default for all protected resources. To disable automatic failover for protected resources or to prevent automatic failover to a backup server, use the Failover section located on the General tab of Server Properties to configure as follows:
For each server in the cluster:
- Bring up the Server Properties dialog just as you would for viewing server properties.
- Select the General tab. In the Failover section of the Server Properties dialog, check the server to disable system and resource failover capabilities. By default, all failover capabilities of LifeKeeper for Windows are enabled.
In the Disable System Failover column, select the server to be disqualified as a backup server for a complete failure of the local server.
In the Disable Resource Failover column, select the server to be disqualified as a backup server for any failed resource hierarchy on this local server. Resource failovers cannot be disabled without first disabling system failover capabilities.
To commit your selections, press the Apply button.
Post your comment on this topic.