Use Control F to search for a specific error code in each catalog. To search for any error code, select the Search button at the top right of the screen.

For a complete list of all the messages you may encounter while using LifeKeeper for Linux, please refer to the Combined Message Catalog.

Code Severity Message Cause/Action
139000 ERROR Cannot find the "oci" command in directories of the PATH. Please confirm that it is installed and the PATH is set correctly.

Cause: Unable to get PATH for "oci" oci command.

Action: Make sure that the oci command is installed and that the installation directory for the oci command is added to your PATH.

139012 ERROR \"oci\" command(request-id:%s) failed with code %s, message \"%s\" and status %s

Cause: Failed to execute the oci command.

Action: Configure the oci command to end successfully based on the status code and message.

139013 ERROR Failed to assign $ip, error:\"$result\"

Cause: Failed to allocate $ip.

Action: Resolve the cause of the error based on the $result details.

139022 ERROR \"oci\" command(request-id:%s) failed with code %s, message \"%s\" and status %s

Cause: Failed to execute the oci command.

Action: Configure the oci command to end successfully based on the status code and message.

139023 ERROR Failed to unassign $ip, error:\"$result\"

Cause: Failed to allocate $ip.

Action: Resolve the cause of the error based on the $result details. If $ip was unallocated before the remove process was performed, make sure that the resource state is OSU and that $ip is not allocated to the target VNIC on the OCI console.

139032 ERROR \"oci\" command(request-id:%s) failed with code %s, message \"%s\" and status %s

Cause: Failed to execute the oci command.

Action: Configure the oci command to end successfully based on the status code and message.

139033 ERROR Failed to \"$ocicmdstr\", unknown error:\"$ip_list\"

Cause: The oci command terminated abnormally due to a cause other than code 139032.

Action: Unknown error: Please take action based on the "$ip_list".

139034 ERROR There is no secondary IPs on $device.

Cause: No secondary IP address has been assigned to $device.

Action: If local recovery is enabled, make sure that local recovery was performed and therefore it recovered from the failure.

139035 ERROR $ip is not assigned to $device.

Cause: $ip is not assigned to $device.

Action: If local recovery is enabled, make sure that local recovery was performed and therefore it recovered from the failure.

139042 ERROR \"oci\" command(request-id:%s) failed with code %s, message \"%s\" and status %s

Cause: Failed to execute the oci command.

Action: Configure the oci command to end successfully based on the status code and message.

139043 ERROR Failed to assign $ip, error:\"$result\"

Cause: Failed to allocate $ip.

Action: Resolve the cause of the error based on the $result details.

139060 ERROR $cmd is invalid.

Cause: $cmd is invalid.

Action: Please contact us.

139061 ERROR OCIVIP does not support IPv6.

Cause: OCIVIP resources do not support use with IPv6.

Action: Please use IPv4.

139062 ERROR $cmd is invalid.

Cause: $cmd is invalid.

Action: Please contact us.

139063 ERROR IPv$ipversion is unknown version.

Cause: The IP address version is incorrect.

Action: Please use IPv4.

139070 ERROR Failed to access the $IMDS_URL with the curl command, status code is $status_code.

Cause: Command curl to $IMDS_URL failed.

Action: Make sure that curl to $IMDS_URL completes successfully.

139071 ERROR Failed to decode JSON, error:\"$e\".

Cause: Failed to decode JSON.

Action: Make sure that the result obtained from Instance Meta Data Service is in JSON format.

139073 ERROR Cannot find the vnicId of $device.

Cause: The vnicId corresponding to $device could not be obtained.

Action: Check if vnicId exists in the JSON record of Instance Meta Data Service.

139074 ERROR Cannot find the subnetcidr of $device.

Cause: The subnetCidrBlock corresponding to $device could not be obtained.

Action: Check if subnetcidr exists in the JSON record of Instance Meta Data Service.

139075 ERROR Cannot find the vRouterIp of $device.

Cause: The virtualRouterIp corresponding to $device could not be obtained.

Action: Check if virtualRouterIp exists in the JSON record of Instance Meta Data Service.

139080 ERROR \"oci\" command(request-id:%s) failed with code %s, message \"%s\" and status %s

Cause: Failed to execute the oci command.

Action: Configure the oci command to end successfully based on the status code and message.

139081 ERROR Failed to get subnet id, error:\"$subnetid\"

Cause: Failed to obtain the subnet id.

Action: Check if the information can be obtained correctly with the following command. The $vnicid corresponds to the VNIC-ID (OCID) of each VNIC assigned to the node.
oci network vnic get --vnic-id $vnicid --raw-output --query 'data."subnet-id"'

139100 ERROR IP address is not specified.

Cause: IP address is not specified.

Action: Make sure the IP address is specified.

139101 ERROR Device is not specified.

Cause: Device is not specified.

Action: Make sure the device is specified.

139105 ERROR Cannot bring OCIVIP resource $Tag in service on server $SysName.

Cause: Failed to restore the OCIVIP resource $Tag on $SysName.

Action: Please refer to the log related to the restore process.

139111 ERROR IP-$ip already exists, and device and netmask are inconsistent with those of $ocivipTag.

Cause: An IP resource corresponding to the IP address of the OCIVIP resource exists, but the device information and netmask information are inconsistent.

Action: Change the configuration of the existing IP resource to have the same settings as the OCIVIP resource and create a dependency with the OCIVIP resource.

139112 ERROR Cannot bring IP resource $iptag in service on server $SysName.

Cause: Failed to restore the IP resource $iptag corresponding to the OCIVIP resource on $SysName.

Action: Review the configuration of the IP resource and make sure that restoring of the IP resource is successful. Then create a dependency with the OCIVIP resource.

139200 ERROR A resource with the specified tag name "%s" already exists on the target machine "%s".

Cause: A resource with the specified tag name already exists on the extended node.

Action: Please use a different tag name or delete the resource with the target tag name of the extended node.

139201 ERROR Template resource "%s" does not exist on the server "%s".

Cause: The resource specified as the extension source does not exist on the node.

Action: Please specify the tag name correctly.

139250 ERROR Failed to valuenetOnOCI, error: \"$stderr_log\".

Cause: valuentOnOCI failed.

Action: The full error message is in $stderr_log. Please take action based on it.

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment