EMCMD <system> SETCONFIGURATION <volume letter> <configuration mask>
This command sets the net alert settings (also referred to as “volume attributes”) for the volume.
The parameters are:
<system> | This can be either the source or the target system. |
<volume letter> | The drive letter of the volume you want to set the configuration on. |
<configuration mask> | This is a bitmask indicating the net alert settings. These bits are defined: 1 — 0×01: All Net Alerts is enabled 2 — 0×02: Broken State Alert is enabled 4 — 0×04: Resync Done Alert is enabled 8 — 0×08: Failover Alert is enabled 16 — 0×10: Net Failure Alert is enabled 32 — 0×20: LifeKeeper Config is enabled 64 — 0×40: Auto Resync is enabled 128 — 0×80: MS Failover Cluster Config is enabled 256 — 0×100: Shared Volume is enabled |
Example to enable MS Failover Cluster Config:
EMCMD . SETCONFIGURATION E 128
Example to clear all flags:
EMCMD . SETCONFIGURATION E 0
Multiple Configuration Example to enable Shared Volume and MS Failover Cluster Config (add decimal values 256 + 128):
EMCMD . SETCONFIGURATION E 384
このトピックへフィードバック