Perform the following on your primary server:
- Select Edit > Server > Create Resource Hierarchy
The Create Resource Wizard dialog will appear.
- Select the Data Replication option from the drop down list and click Next to continue.
- You will be prompted for the following information. When the Back button is active in any of the dialog boxes, you can go back to the previous dialog box. This is helpful should you encounter any error requiring you to correct the previously entered information. You may click Cancel at any time to cancel the entire creation process.
|Switchback Type|| You must select intelligent switchback. This means that after a failover to the backup server, an administrator must manually switch the DataKeeper resource back to the primary server.
CAUTION: This release of SIOS DataKeeper does not support Automatic Switchback for DataKeeper resources. Additionally, the Automatic Switchback restriction is applicable for any other LifeKeeper resource sitting on top of a DataKeeper resource.
|Server||Select the name of the server where the NetRAID device will be created (typically this is your primary server). All servers in your cluster are included in the drop down list box.|
|Hierarchy Type|| Choose the DataKeeper Resource
Select or edit the name of the bitmap file used for intent logging. If you choose None, then an intent log will not be used and every resynchronization will be a full resync instead of a partial resync.
Important: The bitmap file should not reside on a btrfs filesystem (or any other LifeKeeper for Linux unsupported filesystem). Placing data replication bitmap files on a btrfs filesystem (or any other LifeKeeper for Linux unsupported filesystem) will result in an “invalid argument” error when LifeKeeper tries to configure the mirror. The default location for the bitmap file is under /opt/LifeKeeper. This default location should be changed if /opt/LifeKeeper resides on a btrfs filesystem.
Note: btrfs is currently not supported by LifeKeeper for Linux.
|Enable Asynchronous Replication?||
Select Yes to allow this replication resource to support asynchronous replication to target systems. Select No if you will use synchronous replication to all targets. You will be asked later to choose the actual type of replication, asynchronous or synchronous, when the replication resource is extended to each target server. (See Mirroring with SIOS DataKeeper for a discussion of both replication types.) If you want the replication to any of these targets to be performed asynchronously, you should choose Yes here, even if the replication to other targets will be done synchronously.
Note: If you select asynchronous mirroring in an environment where asynchronous mirroring is not supported, the following message is displayed.
Asynchronous mirroring configuration is NOT supported on this kernel (3.10.0-862.el7.x86_64).
The next sequence of dialog boxes depends on which Hierarchy Type you have chosen. While some of the dialog boxes may be the same for each Hierarchy Type, their sequence and the required information may be slightly different. The next three topics take you through the remainder of the Hierarchy creation process.
Post your comment on this topic.