Recovery Kit for SAP MaxDB Hardware and Software Requirements

Your LifeKeeper configuration must meet the following requirements prior to the installation of Recovery Kit for SAP MaxDB. Please see the LifeKeeper for Linux Installation Guide for specific instructions regarding the installation and configuration of your LifeKeeper hardware and software.

Hardware Requirements

• Servers – Servers should be configured in accordance with the requirements described in the LifeKeeper for Linux Installation Guide and the LifeKeeper for Linux Release Notes.

• IP Network Interface Cards – Each server requires at least one Ethernet TCP/IP-supported network interface card. Remember, however, that a LifeKeeper cluster requires at least two communications paths. Two separate LAN-based communication paths using dual independent sub-nets are recommended for heartbeats, and at least one of these should be configured as a private network.

Software Requirements

• TCP/IP Software – Each server in your LifeKeeper configuration requires TCP/IP Software.

• SAP MaxDB/MaxDB Software – Supported versions of SAP MaxDB/MaxDB Software listed in “LifeKeeper for Linux Certification Information” should be installed.

  Note: The same version of the SAP MaxDB software must be installed on all servers in the cluster.

• LifeKeeper Software – It is imperative that you install the same version of the LifeKeeper software and apply the same versions of the LifeKeeper software patches to each server in your cluster.

• Recovery Kit for SAP MaxDB – The Recovery Kit for SAP MaxDB is provided on the LifeKeeper for Linux Installation Image File (Steeleye-lkSAPDB). It is packaged, installed and removed via Red Hat Package Manager, rpm.