The table below lists the Recovery Kit for EC2™ parameters. These values are set by adding them to the %LKROOT%\etc\default\LifeKeeper configuration file.
| Parameter Name | Meaning | Setting Value | Default Value | When parameter takes effect | Notes |
|---|---|---|---|---|---|
| IP_NOLINKCHECK | Disables the link check for the protected network interface. | 0: enabled 1: disabled |
0 | Immediately | This value only applies when protecting an Elastic IP. |
| IP_WAIT_LINKDOWN | Number of seconds to wait in between taking the protected network interface down and back up. A delay between these two actions is necessary in some environments. | Integers | 5 | Immediately | This value only applies when protecting an Elastic IP. |
| IP_MAX_LINKCHK | The maximum number of seconds to wait for the link to come back up after it has been repaired. In some environments, it may be necessary to increase this value. | Integers | 5 | Immediately | This value only applies when protecting an Elastic IP. |
| AWSCLI_CONNECT_TIMEOUT | The connection timeout value in seconds used when running “AWS” commands. It is specified via —cli-connect-timeout argument. | Integers | 10 | Immediately | This is the same parameter as used in Route53. |
| AWSCLI_READ_TIMEOUT | The read timeout value in seconds used when running “AWS” commands. It is specified via —cli-read-timeout argument. | Integers | 5 | Immediately | This is the same parameter as used in Route53. |
| VERBOSE_AWS_ROLE_CHECK | The log file path for additional AWS-specific debug information. | String | None | Immediately | This is the same parameter as used in Route53. |
| AWS_PROFILE | Configures the AWS CLI profile. | String | default | Immediately | This is the same parameter as used in Route53. |
| AWS_SHARED_CREDENTIALS_FILE | Sets the path to the credentials file used to configure the AWS CLI profile. Use a forward slash (/) as the path separator. | String | %USERPROFILE%/.aws/credentials | Immediately | This is the same parameter as used in Route53. |
| AWS_CONFIG_FILE | Sets the path to the config file used to configure the AWS CLI profile. Use a forward slash (/) as the path separator | String | %USERPROFILE%/.aws/config | Immediately | This is the same parameter as used in Route53. |
| EC2_AWS_PROFILE | Configures the AWS CLI profile. It takes precedence over the AWS_PROFILE setting. | String | (Not set) | Immediately |
Post your comment on this topic.