The following is a list of messages output by the script. Each message is written to the event log.
| Code |
Category |
Message |
Description |
| 51050000 |
WARN |
$service_name : Changed the startup type to demand |
The startup type for the HULFT service was not set to manual, so it has been changed to manual. |
| 51050002 |
ERROR |
Failed to stop $service_name (code = $ret) |
The HULFT service stop process has failed. |
| 51050004 |
ERROR |
Failed to start $service_name (code = $ret) |
The HULFT service startup process has failed. |
| 51050005 |
ERROR |
$service_name is not runnring |
Monitoring has failed because the HULFT service is not running. |
| 51050006 |
ERROR |
Failed to open config file |
Monitoring has failed because the HULFT service configuration file cannot be opened. |
| 51050007 |
ERROR |
Failed to check the port used by $service_name (port = $port, code = $ret) |
The verification of the port number specified in the HULFT service configuration file has failed. |
| 51050008 |
ERROR |
Failed to get transport name for $tag |
The resource with the specified tag name does not exist, so the retrieval of resource information has failed. |
| 51050009 |
ERROR |
Failed to get transport name for $tag |
Failed to obtain the HULFT service name from the information of the resource with the specified tag name. |
| 51050015 |
ERROR |
deepCheck is not supported. |
A script has been registered with deepCheck. |
| 51050016 |
ERROR |
Please change exe_path and conf_file of hulft_generic_ark.pl. |
$exe_path or $conf_file is not set. |
| 51050017 |
ERROR |
The exe_path is incorrect or inaccessible. Please specify the correct path (exe_path = $exe_path) |
The specified full path to the HULFT Bin directory is incorrect or inaccessible, resulting in failure. |
| 51050018 |
ERROR |
The conf_file is incorrect or inaccessible. Please specify the correct path (conf_file = $conf_file) |
The specified HULFT configuration file’s full path is incorrect or inaccessible, resulting in failure. |
| 51050019 |
WARN |
Forced the remove process to end normally according to the 窶扠KHULFT_FORCE_REMOVE” parameter. |
Because the LKHULFT_FORCE_REMOVE parameter is enabled, abnormal termination of the remove process is being forced to normal termination. |
| 51050020 |
ERROR |
Timeout occurred during $action action. |
The $action script execution timed out. |
Post your comment on this topic.