EMCMD <system> SETCONFIGURATION <volume letter> <configuration mask>

This command sets the net alert settings (also referred to as “volume attributes”) for the volume.

The parameters are:

<system> This can be either the source or the target system.
<volume letter> The drive letter of the volume you want to set the configuration on.
<configuration mask>

This is a bitmask indicating the net alert settings. These bits are defined:

1 — 0×01: All Net Alerts is enabled

2 — 0×02: Broken State Alert is enabled

4 — 0×04: Resync Done Alert is enabled

8 — 0×08: Failover Alert is enabled

16 — 0×10: Net Failure Alert is enabled

32 — 0×20: LifeKeeper Config is enabled

64 — 0×40: Auto Resync is enabled

128 — 0×80: MS Failover Cluster Config is enabled

256 — 0×100: Shared Volume is enabled

Example to clear all flags:


Multiple Configuration Example to enable Shared Volume and MS Failover Cluster Config (add decimal values 256 + 128):



Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment