EMCMD <system> CREATEMIRROR <volume letter> <target system> <type> [options]
This command creates a mirror between two machines, using the same drive letter on each.
The parameters are:
| <system> | This is the IP address of the source system (see Note below). |
| <volume letter> | This is the drive letter that is being mirrored. This will be both the source and target drive letter. |
| <target system> | This is the IP address of the target system (see Note below). |
| <type> | This is the type of mirror, where type is a single character: A – Create an Asynchronous Mirror S – Create a Synchronous Mirror |
| [options] | Optional arguments that specify behavior deviant from the norm. These can be OR’d together to create a set of options (add decimal values – for example, for option 1 + option 4, place a 5 in the command). They are: 1: Create the mirror without doing a full resync operation. 2: Do not wait for the target side of the mirror to be created before returning. 4: Create with boot-time restrictions in place – essentially treat the create as you would a mirror re-establishment as part of the boot process. This option will check to see if the remote system is already a source and fail the creation if it determines that it was a source. |
IPv4 Example:
EMCMD 192.168.1.1 CREATEMIRROR E 192.168.1.2 A 5
IPv6 Example:
EMCMD 2001:5c0:110e:3304:a6ba:dbff:feb2:f7fd CREATEMIRROR F 2001:5c0:110e:3304:a6ba:dbff:feb2:afd7 A 5
Post your comment on this topic.