EC2 Parameters List

The table below lists the EC2 parameters. These values are set by adding them to the /etc/default/LifeKeeper configuration file. Because none of the components of the Recovery Kit for EC2 are memory resident, changes to these particular values become effective immediately after they are changed in /etc/default/LifeKeeper without requiring a LifeKeeper restart.

Parameter Name	Meaning	Setting Value	Default Value	When to Apply	Notes
EC2_RESTORE_TIMEOUT	Timeout for the resource restore, in seconds.	Integers	300	As required
EC2_REMOVE_TIMEOUT	Timeout for the resource remove, in seconds.	Integers	300	As required
EC2_RECOVER_TIMEOUT	Timeout for the local recovery, in seconds.	Integers	300	As required
EC2_QUICKCHECK_TIMEOUT	Timeout for the quickCheck, in seconds.	Integers	100	As required
IP_NOLINKCHECK	Disables the link check for the protected network interface.	0: enabled 1: disabled	0	As required	This value only applies when protecting an Elastic IP.
IP_WAIT_LINKDOWN	Number of seconds to wait in between taking the protected network interface down and back up. A delay between these two actions is necessary in some environments.	Integers	5	As required	This value only applies when protecting an Elastic IP.
IP_MAX_LINKCHK	The maximum number of seconds to wait for the link to come back up after it has been repaired. In some environments, it may be necessary to increase this value.	Integers	5	As required	This value only applies when protecting an Elastic IP.
AWSCLI_CONNECT_TIMEOUT	The connection timeout value in seconds used when running "AWS" commands. It is specified via --cli-connect-timeout argument.	Integers	10	As required	This is the same parameter as used in Route53.
AWSCLI_READ_TIMEOUT	The read timeout value in seconds used when running "AWS" commands. It is specified via --cli-read-timeout argument.	Integers	5	As required	This is the same parameter as used in Route53.
HTTP_PROXY HTTPS_PROXY NO_PROXY	Set these parameters when using a HTTP proxy for accessing the service endpoint.The value set here is passed to AWS CLI. Please refer to AWS Documentation for details. https://docs.aws.amazon.com/cli/latest/userguide/cli-http-proxy.html	String	(not set)	As required	This is the same parameter as used in Route53 and Quorum.